D-Link DXS-3600 Series Cli Reference Manual page 1013

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
-
Default
By default, VLAN 1 is allowed.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for physical port and port-channel interface configuration.
The command only takes effect when the interface is set to private VLAN trunk promiscuous mode or
trunk secondary mode.
If a VLAN is allowed on a private VLAN trunk port, the port will become the tagged member of the VLAN.
This command is used to support normal VLANs on trunk promiscuous ports or trunk secondary ports. A
packet received on a trunk promiscuous port could belong to the primary VLAN or to the normal VLAN
depending on the incoming VLAN. A packet received on a trunk secondary port could belong to the
secondary VLAN or to the normal VLAN depending on the incoming VLAN.
Example
This example shows how to configure the trunk secondary interface Ethernet 1/0/2 as a normal VLAN 2
member port.
Switch# configure terminal
Switch(config)# interface eth5/0/2
Switch(config-if)# switchport private-vlan trunk allowed vlan add 2
Switch(config-if)#
81-9 show vlan private-vlan
This command is used to display private VLAN configurations.
show vlan private-vlan
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
(Optional) Specifies a range of VLANs. No space is allowed before and
after the hyphen.
1008