D-Link DXS-3600 Series Cli Reference Manual page 1375

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
Issuing this command will create or enter the interface service configuration mode with a specified
encapsulation service VLAN ID. The user can further configure the VPLS or VPWS AC using the
xconnect command. If the interface service configuration is exit without issuing the xconnect command,
the service is automatically deleted.
Example
This example shows how to create an interface service and enter the interface service configuration
mode with service VLAN 1000 on switch port ethernet 1/0/1 and setup an AC to VPWS VC 2.
Switch# configure terminal
Switch(config)# interface ethernet2/0/1
Switch(config-if)# service encapsulation svid 1000
Switch(config-if-srv)# xconnect 110.1.1.12 2 encapsulation mpls
Switch(config-if-xconn)#
118-8 show mpls l2transport vc
This command is used to display the VPWS VC information.
show mpls l2transport vc [VC-ID] [detail]
Parameters
VC-ID
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to display the VPWS VC information.
Example
This example shows how to display information of all VCs.
Switch# show mpls l2transport vc
VC ID
------------ -------------- ---------------- ---------- ---------
1
2
3
4
Specifies the display the specified PW ID only.
Specifies the display detailed PW information.
Peer Local AC
150.1.1.4 eth1/0/1-VLAN2
130.1.1.2 eth1/0/1-VLAN3
140.1.1.2 eth1/0/1-VLAN4
160.1.1.2 eth1/0/1-VLAN4
MTU
1500
1500
1500
1500
1370
Type Oper Status
-----------
Raw Up
Tagged Down
Tagged Up
Tagged Standby