D-Link DXS-3600 Series Cli Reference Manual page 1025

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure the PIM Shortest Path Tree (SPT) threshold value for the specified
groups. Use the no form of this command to restore to the default value.
ipv6 pim spt-threshold {0 | infinity}
no ipv6 pim spt-threshold
Parameters
0
infinity
Default
By default, this option is configured as infinity.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Using the infinity parameter enables all sources for the specified groups to use the shared tree. Using
the 0 parameter to join the SPT immediately after the first packet arrives from a new source.
Example
This example shows how to configure the PIM last-hop router to stay on the shared.
Switch# configure terminal
Switch(config)# ipv6 pim spt-threshold infinity
Switch(config)#
82-15 ipv6 pim ssm
This command is used to configure the Source-Specific Multicast (SSM) group address range. Use the no
command to disable PIM SSM.
ipv6 pim ssm {default | range ACCESS-LIST}
no ipv6 pim ssm
Parameters
default
range ACCESS-LIST
Default
By default, this feature is disabled.
Specifies to establish the source tree right at the arrival of the first
packet.
Specifies to always rely on the shared tree.
Specifies to use the default SSM group address range. The default
SSM group address range is ff3x::/32.
Specifies an access list that defines the user-specified SSM group
address.
1020