D-Link DXS-3600 Series Cli Reference Manual page 1351

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
subnet-vlan
Default
By default, this option is Mac-based VLAN.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
By default, the precedence to classify the VLAN for an untagged packet is MAC-based > Subnet-based >
Protocol VLAN. Use the vlan precedence command to configure the VLAN classification precedence
between MAC-based VLAN and subnet-based VLAN. The command only takes effect on hybrid or dot1q
tunnel interfaces.
Example
This example shows how to configure the interface Ethernet 1/0/1 as a subnet VLAN has higher
precedence.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# vlan precedence subnet-vlan
Switch(config-if)#
116-17 name
This command is used to specify the name of a VLAN. Use the no command to reset the VLAN name to
the default VLAN name.
name VLAN-NAME
no name
Parameters
VLAN-NAME
Default
The default VLAN name is VLANx, where x represents four numeric digits (including the leading zeros)
that are equal to the VLAN ID.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the port subnet-based VLAN classification is precedence
than MAC-based VLAN.
Specifies the VLAN name, with a maximum of 32 characters. The
VLAN name must be unique within the administrative domain.
1346