Show Vlan - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the settings for VLAN classification on a port based on the protocol group.
Example
This example shows how to display the setting for VLAN classification based on the protocol group on a
port Ethernet 1/0/1 to 1/0/3.
Switch# show protocol-vlan interface ethernet 1/0/1-3
Interface
------------ --------------------- ------- ---------
eth1/0/1
eth1/0/2
eth1/0/3
Switch#
This example shows how to display the protocol group profile settings.
Switch# show protocol-vlan profile
Profile ID
----------
1
2
3
Total Entries: 3
Switch#
116-8

show vlan

This command is used to display the parameters for all configured VLANs or one VLAN on the switch.
show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]] | mac-vlan | subnet-vlan]
Parameters
VLAN-ID
interface INTERFACE-ID
Protocol Group ID
1
10
11
12
2
Frame-type Ether-type
----------- ----------------
Ethernet2 0x86DD(IPv6)
Ethernet2 0x0800(IP)
Ethernet2 0x0806(ARP)
(Optional) Specifies a list of VLANs to display the member port
information. If the VLAN is not specified, all VLANs are displayed. The
valid range is from 1 to 4094.
(Optional) Specifies the port to display the VLAN related setting.
VLAN Priority
1 5
3 0
2001 4
3002 1
100 6
1337