D-Link DXS-3600 Series Cli Reference Manual page 1230

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# snmp-server view interfacesMibView 1.3.6.1.2.1.2 included
Switch(config)# snmp-server group guestgroup v3 auth read interfacesMibView
Switch(config)#
101-10 show snmp trap link-status
This command is used to display the per interface link status trap state.
show snmp trap link-status [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display per interface link up/down trap state.
Example
This example shows how to display the interface's link up/down trap state for port Ethernet 1/0/1 to 1/0/9.
Switch# show snmp trap link-status interface ethernet 1/0/1-1/0/9
Interface
-------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
eth1/0/9
Switch#
101-11 show snmp-server
This command is used to display the SNMP server's global state settings and trap related settings.
(Optional) Specifies the interface ID. If no interface is specified, then all
interfaces will be displayed.
Trap state
-------------
Enabled
Enabled
Disabled
Enabled
Enabled
Disabled
Enabled
Enabled
Enabled
1225