D-Link DXS-3600 Series Cli Reference Manual page 1243

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to add one candidate switch to the single IP management group.
Switch# configure terminal
Switch(config)# sim group-member 1 secret
Switch(config)#
102-4 sim holdtime
This command is used to configure the hold-time duration in seconds. One switch (ether the Commander
or Member switch) will clear the information of the other switch, after not receiving single IP management
messages in the duration time. Use the no form to reset the hold-time to the default.
sim holdtime SECONDS
no sim holdtime
Parameters
SECONDS
Default
By default, this value is 100 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
During the hold time, If no SIM protocol message were received, it will:
•
For the Commander switch, clear Member switch information.
•
For the Member switch, clear the Commander switch information and change the role to
Candidate.
Example
This example shows how to configure the single IP management hold-time.
Switch# configure terminal
Switch(config)# sim holdtime 120
Switch(config)#
102-5 sim interval
This command is used to configure the SIM interval in seconds for single IP management protocol
sending messages. Use the no form to set the interval as default.
sim interval SECONDS
no sim interval
Specifies the hold-time in seconds. The range is from 100 to255.
1238