Show Sflow - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The user can only specify a receiver that has its owner name setup. If the receiver associated with the
poller has its owner name is reset, the poller will be reset to the default setting.
Setting the polling interval to 0 disables the polling. An interface can be configured with multiple pollers.
Example
This example shows how to create the poller of instance 1 with receiver as 1 and interval as 20 seconds.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# sflow poller 1 receiver 1 interval 20
Switch(config-if)#

99-4 show sflow

This command is used to display sFlow information.
show sflow [agent | receiver | sampler | poller]
Parameters
agent
receiver
sampler
poller
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display sFlow information. If the MIB is not supported, the MIB version in the
sFlow Agent Version string will be null. If the vendor changes, the organization name in the sFlow Agent
Version string will change too.
Example
This example shows how to display all types of sFlow objects' information.
Switch# show sflow
sFlow Agent Version
sFlow Agent Address
sFlow Agent IPv6 Address
Receivers Information
Index
Owner
(Optional) Specifies to display sFlow agent information.
(Optional) Specifies to display information of all receivers.
(Optional) Specifies to display information of all samplers.
(Optional) Specifies to display information of all pollers.
: 1.3;D-Link Corporation Inc.;1.00
: 10.1.1.1
:
: 1
: collector1
1206