D-Link DXS-3600 Series Cli Reference Manual page 1008

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
None.
Default
None.
Command Mode
MST Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The secondary VLANs need to be mapped to the same MST ID as the primary VLAN if private VLAN is
configured. If the mapping is not synchronized when the user exits the MST Configuration Mode, a
warning message will be displayed. Use the private-vlan synchronize command to synchronize the
MST ID mapping before exiting the MST Configuration Mode. This command will not be saved in the
running configuration.
Example
This example shows how to synchronize the MST mapping before exiting the MST Configuration Mode.
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# instance 1 vlans 1-100
Switch(config-mst)# instance 2 vlans 101-200
Switch(config-mst)# private-vlan synchronize
Switch(config-mst)#
81-4 switchport mode private-vlan
This command is used to specify a port as a private VLAN port. The port type can be a host port,
promiscuous port, trunk promiscuous port or trunk secondary port. Use the no command to revert the port
to the default setting.
switchport mode private-vlan {host | promiscuous | trunk promiscuous | trunk secondary}
Parameters
host
promiscuous
trunk promiscuous
trunk secondary
Default
By default, this option is configured as Hybrid VLAN mode.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies the port as an isolated port or a community port.
Specifies the port as a promiscuous port.
Specifies the port as a trunk promiscuous port.
Specifies the port as a trunk secondary port.
1003