D-Link DXS-3600 Series Cli Reference Manual page 1271

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to specify the polling interval as 15 seconds.
Switch# configure terminal
Switch(config)# storm-control polling interval 15
Switch(config)#
105-3 show storm-control
This command is used to display the current storm control settings.
show storm-control interface INTERFACE-ID [, | -] [broadcast | multicast | unicast]
Parameters
INTERFACE-ID
,
-
broadcast
multicast
unicast
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface ID is not specified, all interfaces configurations will be displayed.
If the packet type is not specified, all types of storm control settings will be displayed.
Example
This example shows how to display the current broadcast storm control settings.
Switch# show storm-control interface range ethernet 1/0/1-1/0/6 broadcast
Polling Interval
Interface
-----------------------------------------------------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
Specifies the port's interface ID.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to display the current broadcast storm setting.
Specifies to display the current multicast storm setting.
Specifies to display the current unicast (DLF) storm setting.
: 15 sec
Action Threshold
Drop 500/300 pps
Drop 80/64 %
Drop 80/64 %
Shutdown 60/50 %
None 60000/50000 kbps
None -
Shutdown Retries
Current State
200 pps Forwarding
20 % Forwarding
70 % Dropped
20 % Forwarding
2000 kbps Forwarding
- Inactive
1266
: Infinite