D-Link DXS-3600 Series Cli Reference Manual page 1358

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
117-5 mtu
This command is used to configure the local AC link MTU value of a VPLS. Use the no form of the
command to restore the default setting.
mtu VALUE
no mtu
Parameters
VALUE
Default
By default, this value is 1500.
Command Mode
VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to set the local AC link's MTU value of a VPLS. The local AC link's MTU value can
be modified only when there is no PW in this VPLS.
Example
This example shows how to configure the local AC link's MTU value to 1000.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# mtu 1000
Switch(config-vfi)#
117-6 name
This command is used to configure the name of a VC. Use no command to reset the name of the VC to
default string.
name STRING
no name
Parameters
STRING
Default
Specifies the local AC link's MTU value of a VPLS that will be
advertised to remote peers in this VPLS. The MTU value must be
same at both the local and remote sites to establish the PW. If the
MTU is specified as 0, then local the MTU will not be advertised to
remote peers in the VPLS. The valid range of value is from 0 to 65535.
Specifies the name of the VC. This string can be up to 64 case-
sensitive characters long.
1353