D-Link DXS-3600 Series Cli Reference Manual page 1021

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to configure VLAN 100 as a PIM passive interface.
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ipv6 pim passive
Switch(config-if)#
82-9 ipv6 pim register-checksum-wholepkt
This command is used to configure the router to calculate the checksum of register message over the
entire PIM message including the data portion. Use the no form of this command to revert to the default
setting.
ipv6 pim register-checksum-wholepkt
no ipv6 pim register-checksum-wholepkt
Parameters
None.
Default
By default, this option is disabled.
By default, the register checksum methodology is PIM RFC-compliant, excluding the data portion in the
Register message.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only affects PIM-SM operation. If this command is specified, then the setting will be
applied to all RP addresses.
Example
This example shows how to enable the register checksum over the whole register message.
Switch# configure terminal
Switch(config)# ipv6 pim register-checksum-wholepkt
Switch(config)#
82-10 ipv6 pim register-probe
This command is used to configure the register-probe time. Use the no form of the command to revert to
the default setting.
ipv6 pim register-probe SECONDS
no ipv6 pim register-probe
1016