D-Link DXS-3600 Series Cli Reference Manual page 1341

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
NETWORK-MASK
ipv6 IPV6-NETWORK-
PREFIX/PREFIX-LENGTH
priority COS-VALUE
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the subnet-vlan ipv4 command to configure a VLAN classification entry for an IPv4 subnet. Use the
subnet-vlan ipv6 command to configure a VLAN classification entry for an IPv6 subnet. The
classification entry will be applied to packets received by the switch. By default, the precedence to
classify the VLAN for an untagged packet is MAC-based > Subnet-based > Protocol VLAN.
Example
This example shows how to configure VLAN classification entries to classify that packets belong to
subnets 20.0.0.0/8, 192.0.0.0/8, and 3ffe:22:33:44::/64 to VLAN 100.
Switch# configure terminal
Switch(config)# subnet-vlan ipv4 20.0.0.0/8 vlan 100 vlan 100
Switch(config)# subnet-vlan ipv4 192.0.0.0/8 vlan 100 priority 4
Switch(config)# subnet-vlan ipv6 3ffe:22:33:44::/64 vlan 100
Switch(config)#
116-7 show protocol-vlan profile
This command is used to display the configuration settings of the protocol VLAN related setting.
show protocol-vlan {profile [PROFILE-ID [, | -]] | interface [INTERFACE-ID [, | -]]}
Parameters
PROFILE-ID
interface INTERFACE-ID
,
-
Default
None.
Specifies the IPv6 network prefix and the prefix length. The prefix
length of IPv6 network address cannot be greater than 64 bits.
(Optional) Specifies the priority CoS value. If not specified, the default
COS is 0.
(Optional) Specifies the protocol group to be displayed.
(Optional) Specifies the port to display the protocol VLAN classification
setting.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is required before or after
the comma.
(Optional) Specifies a range of interfaces. No space is required before
or after the hyphen.
1336