D-Link DXS-3600 Series Cli Reference Manual page 1379

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create a VPWS service and enter the Xconnect configuration mode. When creating
the VPWS on a physical port or link aggregation group, the service is Ethernet-based and this Ethernet
port or link aggregation group is the AC. When creating the VPWS on a VLAN sub-interface of a switch
port interface, the service is Ethernet VLAN-based and this VLAN sub-interface of the switch port is the
AC.
Use the no xconnect command to remove a VPWS service. The settings related to the service are also
removed.
Example
This example shows how to configure the AC from the Customer Edge Bridge (CE) to the PE as the
VLAN 10 of port 1. Assume the VC's ID is 2. For making the VLAN 10 packets from CE one can be
transmitted to the other end through the MPLS network. Configure PE1 and PE2 as follows.
Configuring PE 1:
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)#
Configuring PE 2:
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 110.1.1.12 2 encapsulation mpls
Switch(config-if-xconn)#
1374