D-Link DXS-3600 Series Cli Reference Manual page 1329

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VLAN of the received packets cannot match the VLAN mapping entries or rules on this port, the received
packets will be dropped.
Example
This example shows how to configure an interface port 1 to enable VLAN mapping miss dropping.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport mode dot1q-tunnel
Switch(config-if)# vlan mapping miss drop
Switch(config-if)#
115-7 dot1q-tunnel trust inner-priority
This command is used to set the trusting dot1q priority. Use the no command to remove the setting.
dot1q-tunnel trust inner-priority
no dot1q-tunnel trust inner-priority
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the trusting dot1q priority option, on a dot1q tunnel port, is enabled the priority of the dot1q VLAN
tag in the received packets will be copied to the service VLAN tag.
Example
This example shows how to configure the interface port 1 to trust inner priority.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport mode dot1q-tunnel
Switch(config-if)# dot1q-tunnel trust inner-priority
Switch(config-if)#
115-8 vlan mapping profile
This command is used to create a VLAN mapping profile or enter the VLAN mapping profile configuration
mode. Use the no command to remove the VLAN mapping profile.
vlan mapping profile ID [type [ethernet] [ip] [ipv6]]
1324