D-Link DXS-3600 Series Cli Reference Manual page 1127

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
------------------------------
Auto Alternate Priority : 0
Errored Portlist
CNPV: 2
------------------------------
Auto Alternate Priority : 0
Errored Portlist
!---Output Suppressed.
Switch#
88-8 show qcn cnpv interface
This command is used to display the QCN configuration and status for each CNPV.
show qcn cnpv PRIORITY-VALUE [, | -] interface [INTERFACE-ID [, | -]] [simple]
Parameters
PRIORITY-VALUE [, | -]
INTERFACE-ID [, | -]
simple
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the QCN configuration and status for each CNPV.
Example
This example shows how to display the QCN configuration on all interfaces for CNPV 1.
Switch# show qcn cnpv 1 interface
CNPV: 1
Intf. Defense
: ---
: ---
Specifies the priority value to display. The valid priority value range is
from 0 to 7. Specify multiple priority values, separated by commas or
ranges by using a hyphen. No space before and after the comma or
hyphen.
(Optional) Specifies the interface to display QCN CNPV information.
Specify multiple interfaces, separated by commas or ranges by using a
hyphen. No space before and after the comma or hyphen.
(Optional) Specifies to only display the CND defense mode which
would operate for the CNPV as determined by the LLDP Congestion
Notification TLV.
Admin Auto
1122
Alt. Defense Mode Alt. Pri.