D-Link DXS-3600 Series Cli Reference Manual page 1088

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no match {access-group name ACCESS-LIST-NAME | cos [inner] COS-LIST | [ip] dscp DSCP-
LIST | [ip] precedence IP-PRECEDENCE-LIST | protocol PROTOCOL-NAME | vlan [inner] VLAN-
ID-LIST}
Parameters
access-group name ACCESS-
LIST-NAME
cos COS-LIST
[ip] dscp DSCP-LIST
[ip] precedence IP-
PRECEDENCE-LIST
protocol PROTOCOL-NAME
vlan VLAN-ID-LIST
inner
Default
None.
Command Mode
Class-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
To use the match command, first enter the class-map command to specify the name of the class that will
be used to establish the match criteria. The policy for handling these matched packets is defined in the
policy-map class configuration mode.
The following lists the reference for the supported protocols for the match protocol command.
•
arp - IP Address Resolution Protocol (ARP).
•
bgp - Border Gateway Protocol.
•
dhcp - Dynamic Host Configuration.
•
dns - Domain Name Server lookup.
•
egp - Exterior Gateway Protocol.
•
ftp - File Transfer Protocol.
Specifies an access list to be matched. Traffic that is permitted by the
access list will be classified.
Specifies a specific IEEE 802.1Q CoS value(s) to be matched. The
COS-LIST parameter values are from 0 to 7. Enter one or more CoS
values separated by commas or hyphen for a range list.
(Optional) inner - Specifies to match the inner most CoS of QinQ
packets on a Layer 2 class of service (CoS) marking.
Specifies differentiated service code point values to be matched. Enter
one or more differentiated service code point (DSCP) values separated
by commas or hyphen for a range list. The valid range is from 0 to 63.
(Optional) ip - Specifies that the match is for IPv4 packets only. If not
specified, the match is for both IPv4 and IPv6 packets.
Specifies IP precedence values to be matched. Enter one or more
precedence values separated by commas or hyphen for a range list.
The valid range is from 0 to 7.
(Optional) ip - Specifies that the match is for IPv4 packets only. If not
specified, the match is for both IP and IPv6 packets. For IPv6 packets,
the precedence is most three significant bits of traffic class of IPv6
header.
Specifies the protocol name to be matched.
Specifies the VLAN identification number, numbers, or range of
numbers to be matched. Valid VLAN identification numbers must be in
the range of 1 to 4094. Enter one or more VLAN values separated by
commas or hyphens for a range list.
(Optional) Specifies to match the inner-most VLAN ID in an 802.1Q
double tagged frame.
1083