D-Link DXS-3600 Series Cli Reference Manual page 1391

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
ROUTE-MAP
Default
None.
Command Mode
VRF Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the import route map of one VRF. This is used by the routing protocol
to filter the routes imported to the routing table associated with a VRF instance. One VRF only has one
import route map. The new import route map will overwrite the value set before.
Example
This example shows how to create a VRF VPN-A and set its import route map.
Switch# configure terminal
Switch(config)# ip vrf VPN-A
Switch(config-vrf)# import map rmap1
Switch(config-vrf)#
120-3 ip vrf
This command is used to create a new VRF instance. Use the no form of this command to delete one
VRF instance.
ip vrf VRF-NAME
no ip vrf VRF-NAME
Parameters
VRF-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a new VRF instance and enter the VRF Configuration Mode. After a new
VRF instance is created, a new VRF routing table will be created. With the no form of this command, one
VRF will be deleted. The related VRF routing table will be deleted at the same time and all routing
instances based on this VRF will be destroyed. All IP interfaces associated to this VRF will be restored to
the global routing instance. In the other words, all configurations based on this VRF will be removed.
Specifies the name of import route map of the VRF.
Specifies the name of the VRF.
1386