D-Link DXS-3600 Series Cli Reference Manual page 1253

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
interface INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display Spanning Tree interface level configuration. The command can be used for
all STP versions.
Example
This example shows how to display spanning tree configuration information for interface Ethernet 1/0/1.
Switch# show spanning-tree configuration interface ethernet 1/0/1
eth1/0/1
Spanning tree state : Enabled
Port path cost: 0
Port priority: 128
Port Identifier:
Link type: auto
Port fast: edge
Guard root: Disabled
TCN filter : Disabled
Bpdu forward: Disabled
Switch#
103-4 snmp-server enable traps stp
This command is used to enable the spanning tree to send SNMP notifications for STP. Use the no form
of the command to disable the sending of notifications for STP.
snmp-server enable traps stp [new-root] [topology-chg]
no snmp-server enable traps stp [new-root] [topology-chg]
Parameters
new-root
topology-chg
Specifies the interface ID to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
128.1
(Optional) Specifies the sending of STP new root notification.
(Optional) Specifies the sending of STP topology change notification.
1248