Sflow Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

99. sFlow Commands

99-1 sflow receiver
This command is used to configure a receiver for the sFlow agent. Receivers cannot be added to or
removed from the sFlow agent. Use the no form of this command to reset one receiver to the default
settings.
sflow receiver INDEX [owner NAME] [expiry {SECONDS | infinite}] [max-datagram-size SIZE]
[host {IP-ADDRESS | IPV6-ADDRESS}] [vrf VRF-NAME] [udp-port PORT]
no sflow receiver INDEX
Parameters
INDEX
owner NAME
expiry SECONDS
infinite
max-datagram-size SIZE
host IP-ADDRESS
host IPV6-ADDRESS
vrf VRF-NAME
udp-port PORT
Default
The default owner name is an empty string.
The expiry timer is 0 seconds.
The maximum datagram size is 1400 bytes.
The receiver IP address is 0.0.0.0.
The UDP port number is 6343.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The sFlow agent has a fix number of receivers distinguished by index. They are created in reset the state
by the system and cannot be removed. Configure the owner of an entry before configuring other
parameters of the entry. The owner of an entry can only be configured when the entry is in the reset state.
The user cannot configure the owner name as an empty string. Once the owner is configured, it cannot
be changed directly. It can only be reset by the no sflow receiver command.
Specifies the index of the receivers.
(Optional) Specifies the owner name of the receiver with a maximum of
32 characters. The user cannot directly configure the owner as an
empty string.
(Optional) Specifies the expiration time for the entry. The parameter of
the entry will reset when the timer expired. The range is from 0 to
2000000. The user cannot directly configure the expiry timer as 0.
(Optional) Specifies that the entry will not be expired.
(Optional) Specifies the maximum number of data bytes of a single
sFlow datagram. The valid range is from 700 to 1400.
(Optional) Specifies the IPv4 address of the remote sFlow collector.
(Optional) Specifies the IPv6 address of the remote sFlow collector.
(Optional) Specifies the name of the routing forwarding instance.
(Optional) Specifies the UDP port of the remote sFlow collector. The
default is 6343. The range is from 1 to 65535.
1203