D-Link DXS-3600 Series Cli Reference Manual page 728

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# interface range ethernet 1/0/1-1/0/2
Switch(config-if-range)# no lldp management-address 10.1.1.1
Switch(config-if-range)#
This example shows how to delete the management address FE80::250:A2FF:FEBF:A056 from Ethernet
1/0/3. and 1/0/4.
Switch# configure terminal
Switch(config)# interface range ethernet 1/0/3-1/0/4
Switch(config-if-range)# no lldp management-address FE80::250:A2FF:FEBF:A056
Switch(config-if-range)#
This example shows how to delete all management addresses from Ethernet 1/0/5 and then no
Management Address TLV will be sent on Ethernet 1/0/5.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/5
Switch(config-if)# no lldp management-address
Switch(config-if)#
61-9 lldp med-tlv-select
This command is used to specify which optional LLDP-MED TLV will be transmitted and encapsulated in
the LLDPDUs and sent to neighbor devices. To disable the transmission of the TLVs, use the no form of
this command.
lldp med-tlv-select [capabilities | inventory-management]
no lldp med-tlv-select [capabilities | inventory-management]
Parameters
capabilities
inventory-management
network-policy
power-management
Default
No LLDP-MED TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable or disable
transmitting LLDP-MED TLVs.
(Optional) Specifies to transmit the LLDP-MED capabilities TLV.
(Optional) Specifies to transmit the LLDP-MED inventory management
TLV.
(Optional) Specifies to transmit the LLDP-MED network policy TLV.
(Optional) Specifies to transmit the LLDP-MED extended Power-via-
MDI TLV if the local device is a PSE device or PD device.
723