Reset System - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
109-3 clear running-config
This command is used to clear the system's running configuration.
clear running-config
Parameters
None.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to clear the system's configuration retained in DRAM. The configuration data will
revert to the default settings. Before using this command, save a backup of the configuration using the
copy command or upload the configuration profile to the TFTP server.
This command will clear the system's configuration settings, including IP parameters, but not the stacking
information. Thus, all the existing remote connections will be disconnected. After this command was
applied, the user needs to setup the IP address via the local console.
Example
This example shows how to clear the system's running configuration.
Switch# clear running-config
This command will clear all of system configuration as factory default setting
including IP parameters.
Clear running configuration? (y/n) [n] y
Switch#
109-4

reset system

This command is used to reset the system, clear the system's configuration, then save and reboot the
switch.
reset system
Parameters
None.
Default
1280