D-Link DXS-3600 Series Cli Reference Manual page 1012

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
VLAN-ID
tag
Default
by default, the native VLAN is 1 and in the untagged mode.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for physical port and port-channel interface configuration.
The command only takes effect when the interface is set to private VLAN trunk promiscuous mode or
trunk secondary mode.
When a trunk native VLAN is set to the tagged mode, normally the acceptable frame type of the port
should be set to only accept tagged frames (tagged-only).
When a private VLAN trunk port works in the untagged mode for the native VLAN, transmitting untagged
packets for the native VLAN and tagged packets for all other VLANs and the acceptable frame types of
the port has to be set to admit-all in order to function correctly.
Example
This example shows how to configure interface Ethernet 1/0/2 as a native VLAN member port.
Switch# configure terminal
Switch(config)# interface eth5/0/2
Switch(config-if)# switchport private-vlan trunk native vlan 2
Switch(config-if)#
81-8 switchport private-vlan trunk allowed vlan
This command is used to
switchport private-vlan trunk allowed vlan {all | [add | remove | except] VLAN-ID [,|-]}
no switchport private-vlan trunk allowed vlan
Parameters
all
add
remove
except
VLAN-ID
,
Specifies the VLAN ID. The valid range is from 2 to 4094.
Specifies to enable the tagging mode of the trunk native VLAN.
Specifies to add the port into all the existing VLANs.
Specifies to add the port into the VLAN(s) specified.
Specifies to remove the port from the VLAN(s) specified.
Specifies to add the port into the VLAN(s) not specified.
Specifies the VLAN ID. The valid range is from 2 to 4094.
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No space is allowed before and after the
comma.
1007