D-Link DXS-3600 Series Cli Reference Manual page 1150

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
NUMBER
NAME
Default
None.
Command Mode
Route-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to set the precedence value in the IP header. This command only takes effect when
policy routing involves the IPv4 packet. The precedence can be set using either a number or the
corresponding name.
Example
This example shows how to configure the IP precedence value to 5 (critical) for packets that pass the
route map match.
Switch# configure terminal
Switch(config)# route-map example permit 10
Switch(config-route-map)# match ip address IPACL_01
Switch(config-route-map)# set ip precedence 5
Switch(config-route-map)#
91-12 set metric
This command is used to modify the metric of routes. Use the no form of this command to revert this
value back to the default value.
set metric VALUE
no set metric
Parameters
VALUE
Default
None.
Specifies the number of the precedence value to use in the IP header.
The following numbers represent the following names:
•
0 - Routine.
•
1 - Priority.
•
2 - Immediate.
•
3 - Flash.
•
4 - Flash-override.
•
5 - Critical.
•
6 - Internet.
•
7 - Network.
Specifies the name of the precedence value to use in the IP header.
Specifies the metric of route. The range is from 0 to 4294967294.
1145