D-Link DXS-3600 Series Cli Reference Manual page 1050

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to display BSR information on the BSR router with the Candidate RP
information on the router's interface, VLAN 100.
Switch# show ip pim bsr-router
PIMv2 Bootstrap information
This system is the Bootstrap Router (BSR)
BSR address: 90.1.1.3
BSR Priority: 3, Hash mask length: 30
Next bootstrap message in 0DT00H00M21S
Candidate RP: 90.1.1.3(vlan100), Group ACL: crp-list
Next Cand_RP_advertisement in 0DT00H00M13S
Switch#
This example shows how to display BSR information on the non-BSR router with Candidate RP
information on the router's interface
Switch# show ip pim bsr-router
PIMv2 Bootstrap information
BSR address: 192.168.53.113
BSR Priority: 255, Hash mask length: 30
Next bootstrap message in 0DT00H02M04S
Candidate RP: 192.168.38.111(loopback2), Group ACL: d235.1.3-4/24
Next Cand_RP_advertisement in 0DT00H00M41S
Switch#
83-18 show ip pim interface
This command is used to display the interface information.
show ip pim interface [dense-mode | sparse-mode | sparse-dense-mode] [INTERFACE-ID]
[detail]
Parameters
INTERFACE-ID
detail
dense-mode
sparse-mode
sparse-dense-mode
Default
None.
(Optional) Specifies the interface which to display the interface
information. Only VLAN interface IDs are applicable.
(Optional) Specifies to display the interface information in detail.
(Optional) Specifies to display information only for PIM dense-mode
(Optional) Specifies to display information only for PIM sparse-mode
(Optional) Specifies to display information only for PIM sparse-dense-
mode
1045