D-Link DXS-3600 Series Cli Reference Manual page 847

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
COS-LIST to EXP-VALUE
COS-LIST
Default
None.
Command Mode
MPLS QoS Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The CoS to EXP map is used to map an internal CoS value to an EXP value in the encapsulation of the
label header.
Example
This example shows how to configure the CoS to EXP map in MPLS QoS "policy1".
Switch# configure terminal
Switch(config)# mpls qos policy policy1
Switch(config-mpls-qos)# class map cos-exp 0 to 0
Switch(config-mpls-qos)# class map cos-exp 1 to 1
Switch(config-mpls-qos)# class map cos-exp 2 to 2
Switch(config-mpls-qos)# class map cos-exp 3 to 3
Switch(config-mpls-qos)# class map cos-exp 4 to 4
Switch(config-mpls-qos)# class map cos-exp 5 to 5
Switch(config-mpls-qos)# class map cos-exp 6,7 to 6
Switch(config-mpls-qos)#
71-3 class map exp-cos
This command is used to configure the class EXP to CoS mapping of the policy. Use the no command to
remove the setting.
class map exp-cos EXP-LIST to COS-VALUE
no class map exp-cos [EXP-LIST]
Parameters
EXP-LIST to COS-VALUE
EXP-LIST
Default
Specifies the list of CoS values to an EXP value. The series of CoS
values can be separated by commas (,) or hyphens (-) with no spaces
or hyphens before and after.
Specifies the CoS list.
Specifies the list of EXPs to be mapped to a CoS value. The range of
EXP is from 0 to 7. The series of EXPs can be separated by commas
(,) or hyphens (-) with no spaces or hyphens before and after.
Specifies the EXP list.
842