D-Link DXS-3600 Series Cli Reference Manual page 1378

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, no change is applied to port and VLAN-based ACs and the VLAN tag 0 is added for port-
based ACs.
Command Mode
Xconnect Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure VLAN mode of the PW. The VLAN mode will affect the VLAN handling of
the encapsulated packet. The TPID of the added or changed VLAN tag can be configured using dot1q
tunneling ethertype command. This command can only be applied on a PW of the type is tagged.
Example
This example shows how to configure the VLAN mode to change the VLAN tag to 20.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# service encapsulation svid 10
Switch(config-if-srv)# xconnect 130.1.1.2 2 encapsulation mpls
Switch(config-if-xconn)# vlanmode changevlan 20
Switch(config-if-xconn)#
118-10 xconnect
This command is used to create the VPWS service on the interface. Use the no form of this command to
remove the VPWS service.
xconnect IP-ADDRESS VC-ID encapsulation mpls [manual] [raw | tagged] [mtu 0-65535]
no xconnect
Parameters
IP-ADDRESS
VC-ID
raw
tagged
mtu
Default
None.
Command Mode
Specifies the peer LSR ID that is used to identify the other end PE.
Specifies the PW service instance ID. The range is from 1 to
4294967295.
(Optional) Specifies that the PW type is in the Ethernet-raw mode. For
this type, S-tags will not be sent over the PW.
(Optional) Specifies that the PW type is in the Ethernet-tag mode. For
this type, S-tags will be sent over the PW. By default, the PW type is in
the Ethernet-tag mode.
(Optional) Specifies the local CE-PE link MTU that will be advertised to
remote peer. If specifies the MTU to 0, the LDP will not advertise the
local MTU. The MTU must be same at both local and remote.
Otherwise, the PW will not be setup. The valid range of this value is
from 0 to 65535. If not specified, the default MTU value is 1500.
1373