D-Link DXS-3600 Series Cli Reference Manual page 1322

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# ip verify unicast source
Switch(config-if)#
This example shows how to configure the IP ACL, named "v4isp" and IPv6 ACL, named "v6isp" for
Unicast RPF checking on interface Ethernet 1/0/8.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/8
Switch(config-if)# ip verify unicast source access-group v4isp ipv6-access-group v6isp
Switch(config-if)#
114-3 show ip urpf
This command is used to display the URPF settings.
show ip urpf [INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current settings of URPF. If this command is issued without an interface
ID, only the global Unicast RPF settings will be displayed.
Example
This example shows how to displays the settings of URPF on interfaces Ethernet 1/0/1-3.
Switch# show ip urpf 1/0/1-3
URPF Global State : Enabled (Save And Reboot Required)
Port#
----------
(Optional) Specifies the interface to display. Valid interfaces are
physical interfaces.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
State Reachable-
Via
-------- ----------
reachable-via any allow-default
Allow- IP Access List Name
Default IPv6 Access List Name
--------- --------------------------------
1317