D-Link DXS-3600 Series Cli Reference Manual page 994

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, the port security aging feature is disabled.
The default time is 0 minutes.
The default aging type is absolute.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to disable the ageing or set the ageing time for auto-learned dynamic secured entries.
In order for the inactivity setting to take effect, the FDB table ageing function must be enabled.
Example
This example shows how to apply the aging time for automatically learned secure MAC addresses for
interface Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport port-security aging 1
Switch(config-if)#
This example shows how to configure the port security aging time type for interface Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# switchport port-security aging type inactivity
Switch(config-if)#
78-6 port-security limit
This command is used to configure the maximum secure MAC address number on the system or on the
specified VLAN. Use the no form of this command to reset to the default setting.
port-security limit {global | vlan VLAN-ID [, | -]} VALUE
no port-security limit {global | vlan VLAN-ID [, | -]}
Parameters
global
vlan VLAN-ID
VALUE
Default
None.
Command Mode
Specifies that this setting will be applied to the system.
Specifies the VLAN ID that will be used.
Specifies the maximum number of port security entries that can be
learned on the system or specified VLAN. The range is from 1 to
12288. If the setting is smaller than the number of current learned
entries, the command will be rejected.
989