D-Link DXS-3600 Series Cli Reference Manual page 1042

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only takes effect when the interface is PIM enabled.
A PIMv2 router learns PIM neighbors via the PIM hello message. This command configures the frequency
of the hello message. Routers configured for IP multicasting send PIM hello messages to detect PIM
routers. For SM, hello messages also determine the router to act as the designated router for each LAN
segment. The configured query interval is also used as the value for hold time. By configuring a smaller
period for the interval, the unresponsive neighbor can be discovered faster and thus the failover and
recovery will become more efficient.
Example
This example shows how to configure the PIM hello interval to 45 seconds.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip pim query-interval 45
Switch(config-if)#
83-8 ip pim register-checksum-wholepkt
This command is used to enable the calculating of the register checksum value over the whole packet.
Use the no form of this command to disable calculating the register checksum over the whole packet.
ip pim register-checksum-wholepkt rp-address-list ACCESS-LIST-NAME
no ip pim register-checksum-wholepkt
Parameters
ACCESS-LIST-NAME
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Specifies the interval at which the hello message is sent.
Specifies the name of the IP access list which specifies a list of RP
addresses. This is the address in the source address field of the
access list entry.
1037