D-Link DXS-3600 Series Cli Reference Manual page 1357

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command can be used to configure TPID of the VLAN tag of all PWs belong to the VPLS. If the
VLAN mode is addvlan or changevlan, the TPID of the modified VLAN tag will be set to the configured
value. This command can only be applied on a VPLS of which the PW type is tagged.
Example
This example shows how to configure the VLAN tunneling TPID to 0x88a8 of a VPLS.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# dot1q tunnel ethertype 0x88a8
Switch(config-vfi)#
117-4 l2 vfi
This command is used to create a VPLS instance and enter the VFI configuration mode. Use the no
command to delete a VPLS instance.
l2 vfi VPLS-NAME manual
no l2 vfi VPLS -NAME
Parameters
VPLS-NAME
manual
Default
By default, no VPLS instance is created.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a VPLS instance and enter the VFI configuration mode. The VPLS name
is used to locally identify a unique VPLS on the switch.
Example
This example shows how to create a VPLS instance named "vpls100" and enter the VFI configuration
mode.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)#
Specifies the VPLS instance name. The maximum length is 32
characters.
Specifies to manually configure neighbors, using LDP for signaling.
1352