D-Link DXS-3600 Series Cli Reference Manual page 1280

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
108-2 flowcontrol
This command is used to configure the flow control capability of the port interface. Use the no form of
command to revert to the default setting.
flowcontrol {on | off}
no flowcontrol
Parameters
on
off
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can only assure that the flow control capability has been configured in the switch software
and not guarantee the actual hardware operation. The actual hardware operation may be different to the
settings that have been configured on the switch because the flow control capability is determined by both
the local port/device and the device connected at the other end of the link, not just by the local device.
If the speed is set to the forced mode, the final flow control setting will be determined by the configured
flow control setting. If the speed is set to the auto mode, the final flow control setting will be based on the
negotiated result between the local side setting and the partner side setting. The configured flow control
setting here is the local side setting.
If no option is selected for the direction, both send and receive is used.
Example
This example shows how to enable the flow control on interface Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# flowcontrol on
Switch(config-if)#
108-3 mdix
This command is used to configure the port Media-Dependent Interface Crossover (MDIX) state. Use the
no form of command to revert to the default setting.
mdix {auto | normal | cross}
no mdix
Specifies to enable a port to send PAUSE frames or process PAUSE
frames from remote ports.
Specifies to disable the ability for a port to send or receive PAUSE
frames.
1275