D-Link DXS-3600 Series Cli Reference Manual page 1381

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
STRING
Default
By default, no authentication is used.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable VRRP authentication on an interface. The authentication is applied to all
virtual routers on this interface. The devices in the same VRRP group must have the same authentication
password.
Example
This example shows how to configure one interface's VRRP authentication:
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# vrrp authentication test
Switch(config-if)#
119-3 vrrp ip
This command is used to create a VRRP group on an interface. Use the no form of this command to
remove a VRRP group.
vrrp VRID ip IP-ADDRESS
no vrrp VRID
Parameters
VRID
IP-ADDRESS
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the plain text authentication password. This string can be up
to 16 characters long.
Specifies the virtual router identifier that identifies the VRRP group.
The valid range is from 1 to 255.
Specifies the IP address for the created virtual router group.
1376