D-Link DXS-3600 Series Cli Reference Manual page 1354

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
116-19 show vlan counting
This command is used to display the control entries for the traffic statistics on specified Layer 2 VLAN
interface(s).
show vlan counting [interface INTERFACE-ID] [rx | tx]
Parameters
interface INTERFACE-ID
rx
tx
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
None.
Example
This example shows how to display all Layer 2 VLAN statistics control entries.
Switch# show vlan counting
VLAN Frame Type
---- ------------
2 RX Unicast
3 RX Any
4 RX Multicast
10 RX Broadcast
2 TX Unicast
3 TX Any
4 TX Multicast
100 TX Broadcast
Total Entries: 8
Switch#
(Optional) Specifies the Layer 2 VLAN interface(s) of the control entry
to be displayed. If no Layer 2 VLAN interface is specified, then all
control entries will be displayed.
(Optional) Specifies to display control entries for ingress traffic.
(Optional) Specifies to display control entries for egress traffic.
Ports
----------------------------------------------------
1:1
1:1-1:5
1:1
2:10-2:12
1349