D-Link DXS-3600 Series Cli Reference Manual page 1334

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the 802.1Q tunneling configuration on interfaces.
Example
This example shows how to display all 802.1Q tunnel ports configuration.
Switch# show dot1q-tunnel
dot1q Tunnel Interface: eth1/0/1
Trust inner priority
VLAN mapping miss drop
VLAN mapping profiles
dot1q Tunnel Interface: eth1/0/2
Trust inner priority
VLAN mapping miss drop
Insert dot1q tag
Switch#
115-13 show vlan mapping
This command is used to display the VLAN mapping configuration.
show vlan mapping [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
: Enabled
: Disabled
: 1, 2, 3
: Disabled
: Enabled
: VLAN 10
(Optional) Specifies the interfaces that will be displayed. If not
specified, display the all VLAN mappings.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
1329