Weighted Random Early Detection (Wred) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
122. Weighted Random Early Detection (WRED)
Commands
122-1 clear random-detect drop-counter
This command is used to clear WRED drop counters.
clear random-detect drop-counter {all | interface INTERFACE-ID [, | -]}
Parameters
all
interface INTERFACE-ID [, | -]
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Only physical ports are valid for this command.
Example
This example shows how to clear WRED drop counters on Ethernet 1/0/1.
Switch# clear random-detect drop-counter interface ethernet 1/0/1
Switch#
122-2 random-detect
This command is used to enable the WRED function. Use the no form of this command use to disable the
WRED function.
random-detect COS-VALUE [profile ID]
no random-detect COS-VALUE
Parameters
COS-VALUE
profile ID
(Optional) Specifies to clear all counters.
(Optional) Specifies the interface ID to be cleared. Specify multiple
interface IDs, which are separated by commas (,) or hyphens (-). No
space is before or after the commas or hyphens.
Specifies the CoS queues on which the WRED state will be set. The
valid range is from 0 to 7.
(Optional) Specifies the WRED profile that will be applied. If not
1397