DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
snmp trap link-status
no snmp trap link-status
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable or disable the sending of link-up and link-down traps on an interface.
Example
This example shows how to disable the generation of link-up and link-down traps on Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# no snmp trap link-status
Switch(config-if)#
101-23
snmp-server context-map
This command is used to configure the SNMP context mapping table. Use the no command to remove
the configuration.
snmp-server context-map CONTEXT [instance-id INT] [instance-name NAME] [vrf-name NAME]
no snmp-server context-map CONTEXT
Parameters
CONTEXT
instance-id INT
instance-name NAME
vrf-name NAME
Default
None.
Command Mode
Specifies the VACM context name. This name can be up to 32
characters long. The name must start with a letter and end with a letter
or digit. Interior characters can be letters, digits, and hyphens.
Specifies the instance ID of OSPF. The range is from 1 to 65535.
Specifies the instance name of OSPF. This name can be up to 12
characters long.
Specifies the VRF name. This name can be up to 12 characters long.
1234