D-Link DXS-3600 Series Cli Reference Manual page 1291

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# copy tftp: //10.1.1.254/image.had flash: image.had
Address of remote host [10.1.1.254]?
Source filename [image.had]?
Destination filename [image.had]?
Accessing tftp://10.1.1.254/image.had...
Transmission start...
Transmission finished, file length 8315060 bytes.
Transmission to slave start.................
Transmission to slave finished, file length 8315060 bytes.
Please wait, programming flash.............. Done.
Wait slave programming flash complete...
Done.
Switch#
109-7 ip tftp source-interface
This command is used to specify the interface whose IP address will be used as the source address for
initiating TFTP packets. To revert to the default setting, use the no form of this command.
ip tftp source-interface INTERFACE-ID
no ip tftp source-interface
Parameters
INTERFACE-ID
Default
The IP address of the closest interface will be used.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the command to specify the interface whose IP address will be used as the source address for
initiating TFTP packets. To load the software from the out of band management port, specify the interface
ID for the out of band management port.
Example
This example shows how to download software from the out of band management port.
Switch# configure terminal
Switch(config)# ip tftp source-interface mgmt0
Switch(config)#
Done.
Specifies the interface whose IP address will be used as the source
address for initiating TFTP packets.
1286