D-Link DXS-3600 Series Cli Reference Manual page 1019

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
82-6 ipv6 pim hello-interval
This command is used to configure the frequency of PIM hello messages. Use the no form of this
command to return to the default interval.
ipv6 pim hello-interval SECONDS
no ipv6 pim hello-interval
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only valid for the VLAN interface. A PIM router learns PIM neighbors via the hello
message. Routers configured for IP multicast send PIM hello messages to detect PIM routers. For SM,
hello messages are also used to determine which router will be elected as the designated router for each
LAN segment.
Example
This example shows how to configure the PIM hello interval to 45 seconds.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 pim hello-interval 45
Switch(config-if)#
82-7 ipv6 pim join-prune-interval
This command is used to configure the frequency of PIM periodic join and prune message. Use the no
form of this command to return to the default interval.
ipv6 pim join-prune-interval SECONDS
no ipv6 pim join-prune-interval
Parameters
SECONDS
Default
By default, this value is 60 seconds.
Specifies the interval, in seconds, between Hello messages. The range
is from 1 to 18000.
Specifies the interval, in seconds, between Join and Prune messages.
The range is from 1 to 18000.
1014