D-Link DXS-3600 Series Cli Reference Manual page 1356

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
all
VPLS-NAME
peer
IP-ADDRESS
VC-ID
ac
INTERFACE-ID
vlan VLAN-ID
address MAC-ADDR
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear VPLS MAC addresses.
Example
This example shows how to clear all VPLS MAC addresses.
Switch# clear mac-address-table vpls dynamic all
Switch#
117-3 dot1q tunneling ethertype
This command is used to configure the TPID of the VLAN tag to be added or changed for the
encapsulated packet. Use the no command to return this value to the default setting.
dot1q tunneling ethertype VALUE
no dot1q tunneling ethertype
Parameters
VALUE
Default
By default, this value is 0x8100.
Command Mode
VFI Configuration Mode.
Specifies that all dynamic VPLS MAC address will be cleared.
(Optional) Specifies the VPLS name. This name can be up to 32
characters long.
(Optional) Specifies the peer in the VPLS.
(Optional) Specifies the LSR ID that is used to identify the PE to which
the peer belongs to.
(Optional) Specifies the Pseudo-Wire (PW) ID. The range is from 1 to
4294967295.
(Optional) Specifies the local AC in the VPLS.
(Optional) Specifies the interface ID.
(Optional) Specifies the VLAN ID.
(Optional) Specifies the MAC address to be cleared.
Specifies the outer TPID for the service VLAN tag. The value is in the
hexadecimal form. The range is from 0x1 to 0xFFFF.
1351