Set/Resume/Cancel Switch Test/Replacement - Acura 3.5 RL Manual

Set/Resume/Cancel Switch Test/Replacement

SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS (section 24) before performing repairs or service.
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's pre-
set buttons.
2. Disconnect the battery negative cable, then discon-
nect the positive cable, and wait at least 3 minutes.
NOTE: The PCM memory must be reset after recon-
necting the battery (see page 11-125).
3. Disconnect the airbag connectors.
Driver's Side:
Remove the access panel from the steering wheel,
then disconnect the 2P connector between the
driver's airbag and cable reel.
DRIVER'S
AIRBAG
2P CONNECTOR
CABLE REEL
CONNECTOR
ACCESS PANEL
Front Passenger's Side:
Remove the glove box (see
Disconnect the front passenger's 2P connector
from the SRS main harness.
FRONT PASSENGER'S
AIRBAG
2P CONNECTOR
4. Remove the dashboard lower cover.
5. Disconnect the combination switch 20P connector
from the main harness.
20P CONNECTOR
Wire side of
female terminals
section 20).
SRS MAIN HARNESS