Configuration Requirements For Cpi - Avaya Octel 200 Installation And Maintenance Manual

Configuration Requirements for CPI

Use the following requirements when configuring the Octel 200/300.
COS
System Parameter
SLOTS Table
PB60019-01
The following applies to NEC-2400 integrations when the switch
software level is lower than 5200 version 9.03.
Do not use COS Attribute 15 for extensions forwarded to the Octel
200/300. RNA count must be less than five and less than the RNA
forward count configured in the PBX.
The ability to do a blind transfer from a single line set is included with
5200 level software, version 9.03.
System Parameter 99 — RINGBACKS BEFORE ANSWERING CX
PORT
System Parameter 100 — RINGBACKS BEFORE ANSWERING
MX PORT
System Parameter 117 — RINGBACKS BEFORE ANSWERING
AX PORT
In most cases the Octel 200/300 receives the call record within the first
ring of the forwarded call. The Octel 200/300 answers the call as soon
as the call record is received. If after "n" rings (defined in System
Parameter 99, 100 and 117) the call record has not been received, the
caller hears the company greeting instead of the called party's
extension/name or greeting. As a fail-safe measure, it is recommended
that the value of System Parameters 99, 100, and 117 be set at 5.
System Parameter 130 — SEND DTMF A FOR FORWARDED
CALLS
Modify the value of this System Parameter to be YES. This enables the
Octel 200/300 to recognize when a message waiting call or screened
transfer has forwarded back to an Octel 200/300 port.
The SLOTS Table is used to configure ports in the NEAX-2400
Adaptive Integration.
Configure all ports that answer calls forwarded to the Octel 200/300 for
either AX, CX, or MX mode. Ensure that port extensions match the
PBX extensions; otherwise, call records will not be correctly received.
Refer to the Configuration volume, Slots Table chapter, for further
information on configuring the SLOTS Table.
NEAX-2400 Adaptive Integration
Octel 200/300
5-7
S.4.1