Trunk Group Data Entry Screen - Avaya Octel 200 Installation And Maintenance Manual

7.2-22 Integration Volume
Configuration
The trunk group configuration is as follows:
1. List the System 75 trunk groups. Note those which are answered directly by the Octel 200/300
2. Use the CHANGE command to modify one of the trunk groups. Figure 7.2-11 shows an example of
the Trunk Group data entry screen.
3. Change the trunk group's name to fit this format:
T-XXX
XXX is the trunk group's TAC (trunk access number).
4. If the trunk group is to be answered directly by the Octel 200/300 enter Octel 200/300 for the
Incoming Destination. Also write down the Group Number and the TAC. These numbers are
needed for the Octel 200/300 configuration.
5. Repeat steps 2 through 4 for each trunk group listed in step 1.
Group Number: __
Group Name: T-XXX
Direction: __________
Dial Access? _
Queue Length: ___
200/300
Prefix-1? _
TRUNK PARAMETERS
Trunk Type: ____________
Outgoing Dial Type: ________
Trunk Termination: ______
ACA Assignment? _
Short Holding Time(secs.): ____
Answer Supervision Timeout: ______
italics Entry described in the instructions
blank Leave unchanged
Octel 200/300 S.4.1
TRUNK GROUP
Group Type: __
Outgoing Display? _
Busy Threshold: __
Restriction: ____
Figure 7.2-11 Trunk Group Data Entry Screen
LEGEND for Figure 7.2-11
COR: __
Data Restriction? _
Night Service: EXTNH
Incoming Destination:
Digit Absorption List: _
Disconnect Timing(msec): ____
Long Holding Time(hours): ___
Short Holding Threshold: ___
Maintenance Test? ___
Suppress # Outpulsing? ____
Page 1 of 5
SMDR Reports? _
TAC: XXX
Octel
PB60019-01