Installing The Sic8 Board - Avaya Octel 200 Installation And Maintenance Manual

Installing the APIC Board
This section describes the procedure for installing the APIC board. Reconnect the 25-pair cable to the
Octel 200/300. Before proceeding with installation, note that there are 18 LEDs on the front edge of the
APIC, near the top of the card. The first through fourteenth LEDs are used to indicate card status and are,
from top to bottom,
LED Description
Follow the steps below to install the APIC board. The Power On Routine refers to the LEDs by the above
names.
Caution!
1. Plug the 25-pair cable into the APIC slot.
2. Put on antistatic wrist strap. Connect it to an unpainted portion of the cabinet.
3. While holding top and bottom edges, slide the APIC card into the card cage. Pivot the card ejectors
as needed to grip small flanges on the front edges of the card cage.
Caution!
4. Firmly seat the APIC card connectors into the motherboard by pressing ejectors against the front
edge of the card. The ejectors clips onto small pins on the integration card when the connectors have
seated.
Refer to the Power-on Routine section that follows to monitor the LEDs.
5. Test the system for proper operation. Refer to the Testing Adaptive Integration section.
Once the down LED is OFF, the good LED is ON (green), and the yellow LEDs are ON, the card and
ports are working properly.
PB60019-01
DOWN LED
GOOD LED
Port 1 LED
.
.
.
Port 12 LED
Unused 13 −16
All cross-connections to the PBX must be completed
before proceeding. Changes to connections should
only be made while the integration card is not
installed in the Octel 200/300. Cross-connecting
integration links when the integration card is installed
may result in damage to the integration card.
Do not slam the integration card into the cabinet,
as this may damage the board or motherboard
connectors.
Definity G3 Adaptive Integration with APIC
LED Color
Red
Green
Yellow
.
.
.
Yellow
−−
12.1-35
Octel 200/300 S.4.1