Octel 200/300 Configuration - Avaya Octel 200 Installation And Maintenance Manual

3-12 Integration Volume
3.5

OCTEL 200/300 CONFIGURATION

To implement Enhanced DTMF In-band Integration, the following tables are used. Refer to the
Configuration volume for specific configuration information for each table.
USER Table
SLOTS Table
COS Table
TRANSLATION Table
TRUNK GROUP Table
SYSTEM PARAMETER
Table
DELAY APPLICATION
Table
Octel 200/300 S.4.1
All extension numbers configured for In-band Integration must match
the mailbox number; therefore, shared extensions with different
mailbox numbers are not allowed.
In the Octel 200/300, the DTMF In-band port should be configured as
an AX mode port.
Configure COS Attribute 68 — THIS PORT IS DTMF INTEGRATED,
for all ports receiving DTMF In-band calls.
The TRANSLATION Table, if configured, is used to translate the
source and destination fields.
.
If a transferred call shows a port as the source and the
TRANSLATION Table is used, the translated value of the
extension must be used in the SLOTS Table.
Configure this table if the PBX supports trunk group numbers on call
records for incoming external calls.
System Parameter 176 — FIXED LENGTH FOR SOURCE FIELDS
System Parameter 177 — FIXED LENGTH FOR DESTINATION
FIELDS
System Parameter 178 — FIXED LENGTH FOR TRUNK FIELDS
System Parameter 179 — FIXED LENGTH FOR UNUSED FIELDS
.
In addition, message waiting notification is supported normally
with System Parameters 79−84.
Source extension
-
Destination extension
-
Trunk group
-
Miscellaneous information
-
Delay Application 110 — FIRST DIGIT TIMEOUT WHILE WAITING
FOR DTMF CALL RECORD
Delay Application 111 — INTERDIGIT TIMEOUT WHILE WAITING
FOR DTMF CALL RECORD
Delay Application 112 — DELAY BEFORE PLAYING PROMPT
AFTER RECEIVING CALL RECORD
PB60019-01