Testing Of Adaptive Integration Features - Avaya Octel 200 Installation And Maintenance Manual

The installation procedure refers to the LEDs by the above names. Follow the steps below to install the
ATTIC board.
Caution!
1. Plug the 25-pair cable into the ATTIC slot.
2. Put on antistatic wrist strap. Connect it to an unpainted portion of the cabinet.
3. While holding top and bottom edges, slide the integration card into the card cage.
4. Pivot the card ejectors as needed to grip small flanges on the front edges of the card cage.
5. Firmly seat the integration card connectors into the motherboard by pressing ejectors against the
front edge of the card. The ejectors clips onto small pins on the integration card when the connectors
have seated.
Caution!
Once the integration card is installed, the red LED comes ON. When selftest diagnostics are
complete, the green LED comes ON. When the card has been initialized and is ready for operation,
the red LED goes OFF within five minutes.
The ATTIC then verifies link operation. Verification takes about two minutes. Once a link is verified
as working, the yellow LED associated with each link is turned ON. If all yellow LEDs do not turn
ON, there is a link problem. Troubleshoot the link using the display phone. If the link is good,
replace the ATTIC board.
6. Use the Courtesy Up command to initialize the integration card. At the @ prompt enter
CU x y
x = slot number; y = unit number
If there are two units, both units would have to be initialized.
Repeat this step for unit 2.
7. Test the system for proper operation.
Once the down LED is OFF, the good LED is ON, and the yellow LEDs are ON, the card is working
properly.

Testing of Adaptive Integration Features

This section describes the procedures for testing Adaptive Integration features, once the ATTIC board is
installed and operational and the PBX 25-pair cable is re-connected to the correct Octel 200/300 ports,
proceed as follows:
PB60019-01
All cross-connections to the PBX must be completed
before proceeding. Changes to connections should
only be made while the integration card is not
installed in the Octel 200/300. Cross connecting
integration links when the integration card is installed
may result in damage to the integration card.
Do not slam the integration card into the cabinet, as
this may damage the board or motherboard
connectors.
DEFINITY G3 Adaptive Integration
Octel 200/300
7.1-39
S.4.1