7.3.6 At&T System 85 Maintenance - Avaya Octel 200 Installation And Maintenance Manual

7.3-42 Integration Volume
7.3.6 AT&T SYSTEM 85 MAINTENANCE
The following are the maintenance commands for the System 85 integration.
TEST INTEGRATION
TE INT x y
TE INT x y
LIST INTEGRATION
L INT x y
CLEAR INTEGRATION
C INT x y
The following are definitions of the fields displayed when listing the state of the ATTIC board.
Card ID
Octel 200/300 S.4.1
This command tells the ATTIC to run its link selftest. The form of the
command is
TE INT x y
where x is the slot number
where y is the integration unit number (1 or 2)
Any hardware errors found are logged in the Hardware Error Table.
Refer to the Installation and Maintenance volume, System Errors and
Traffic Pegs chapter, for more information.
This command resets the ATTIC board and takes approximately 30
seconds. The form of the command is
TE INT x y 2
where x is the slot number
where y is the integration unit number (1 or 2)
where 2 is the reset command flag
This command lists the current state of the ATTIC board, the diagnostic
status, the status of the links, and the pegs. The form of the command is
L INT x y
where x is the slot number
where y is the integration unit number (1 or 2)
This command clears the ATTIC board pegs. The form of the command
is
C INT x y
x
where is the slot number
where y is the integration unit numbers (1 or 2)
The CARD ID states the type of equipped integration card.
PB60019-01