Installation Of The Slic Board - Avaya Octel 200 Installation And Maintenance Manual

Message servers

Hide thumbs Also See for Octel 200:

Table of Contents

Integration Volume

INSTALLATION OF THE SLIC BOARD

There are LEDs on the front edge of the SLIC. These are used to indicate card status from top to bottom:

The installation procedure refers to the LEDs by the above names. Follow the steps below to install the

1. Plug the 25-pair cable into the SLIC connector.

2. Put on antistatic wrist strap. Connect it to an unpainted portion of the cabinet.

3. Plug the card into the slot that has been configured for integration. While holding top and bottom

edges, slide the integration card into the card cage.

4. Pivot the card ejectors as needed to grip small flanges on the front edges of the card cage.

5. Firmly seat the integration card connectors into the motherboard by pressing ejectors against the

front edge of the card. The ejectors clips onto small pins on the integration card when the connectors

have seated.

Once the integration card is installed, the red LED comes ON. When selftest diagnostics are

complete, the green LED comes ON. When the card has been initialized and is ready for operation,

the red LED goes OFF within five minutes. Refer to Table 6-3.

The SLIC then verifies link operation. Verification takes about two minutes. Once a link is

verified as working, the yellow LED associated with each link is turned ON. If all yellow LEDs do

Octel 200/300

Integration Unit 1 Link 1

Integration Unit 1 Link 2

Integration Unit 2 Link 1

Integration Unit 2 Link 2

All cross-connections to the PBX must be completed

before proceeding. Changes to connections should

only be made while the integration card is not

installed in the Octel 200/300. Cross connecting

integration links when the integration card is installed

may result in damage to the integration card.

Do not slam the integration card into the cabinet, as

this may damage the board or motherboard

Table of Contents