Centrex Configuration - Avaya Octel 200 Installation And Maintenance Manual

Message servers

Hide thumbs Also See for Octel 200:

Table of Contents

Integration Volume

CENTREX CONFIGURATION

Each Octel 200/300 port requires a 2500-type Centrex station extension. The appropriate number of

Centrex station lines for the Octel 200/300 ports must be provided and programmed as a multiline hunt

group (MLHG) with SMDI.

All stations to be call forwarded to the Octel 200/300 /SMDI ports require each of the following to be

programmed at the PE. The Adaptive Integration option, which includes both Called Party Identification

(CPI) and Message Waiting Indication (MWI) features, is required.

All Centrex lines that forward to the Octel 200/300 must be programmed by the PE to generate a call

record over the SMDI link.

The lines must also be programmed to forward to the Octel 200/300 multiline hunt group on the

desired condition.

Ring-no-answer forwarding to the SMDI group.

Busy Forwarding to the SMDI group. (For Called Party Identification)

CFUS (Call Forward Unrestricted Source) This enables internal call forwarding to follow the

same routing as external forwarding. (For Called Party Identification)

Phones that have mailboxes on the Octel 200/300 should be set up in the Centrex switch to have

stutter dial tone if MWI is desired.

Octel 200/300

The following applies to 1AESS and some DMS 100

central offices.

Do not forward a station/extension to another station

that subsequently forwards to the Octel 200/300. The

SMDI record shows only the last station that

forwarded before going to the Octel 200/300 hunt

group, and the prompt gives that last station number,

not the original number entered.

However, for some DMS 100 central offices using

BCS 30 software, or higher, and for 5ESS central

offices, sequential forwarding is supported, and the

call record will reflect the originally called extension.

Called Party Identification)

Table of Contents