Octel 200/300 Requirements; 7.1.7 Installation Checklist; Pre-Installation - Avaya Octel 200 Installation And Maintenance Manual

Message servers

Hide thumbs Also See for Octel 200:

Table of Contents

This section offers a checklist of issues relating to the Octel 200/300 and to the DEFINITY G3i. The list

is presented in the order in which the installation process should be followed. For details regarding any

topic, refer to the sections of this chapter pertaining to the issue.

DEFINITY G3i must provide analog telephone ports (2500 type) from its

analog line circuit cards to each of the ports in the Octel 200/300 cabinet.

DEFINITY G3i must provide a digital port for each of the ATTIC links.

25-pair cable per slot (male to female).

PBX must be DEFINITY G3i or G3r.

List the database. Highlight areas where changes are

Make note of the following definitions for ports:

Number of ports

Port extension number

Integrated (Y/N)

If different company greetings will be used, enter the

Access Code for each route into the TRUNK GROUP

Table. Obtain Access Code numbers from AT&T vendor.

Set the number of ring cycles before forwarding for all

mailboxes that are forwarded to the Octel 200/300to be one

less than the number of ring cycles in the DEFINITY G3i.

Configure a slot in the SLOTS Table for every integration

card installed.

Table 7.1-2 DEFINITY G3i Software and Hardware Checklist

Table 7.1-3 Octel 200/300 Requirements

DEFINITY G3 Adaptive Integration

Octel 200/300

Chapters

Table of Contents